Upgraded Silent Board with TMC2208 Driver For Ender 5 PLUS/CR-10S/CR-X

1,024 kr

Manufacturer: Creality

Utsolgt

  Send meg epost når varen er på lager!
  Du vil få en epost når varen er tilgjengelig!

cancel?
Produktnummer: PN24208_1 Kategorier: , , ,

Beskrivelse

Upgraded Silent Board with TMC2208 Driver For Creality Ender-5 Plus/CR-X 3D/CR-10S Printer

This option is the separate upgraded for Ender 5 PLUS, just plug it in and you could start printing.
Notice: This new upgraded silent mainboard does not currently come pre-installed on Ender 5 PLUS.

Features:
-Super Quiet and Noise Reduction. Use TMC2208 Stepper Motor Drivers, which the key component to eliminate the printer’s motor when printing.
-Bootloader pre-installed. The firmware can be modified by ARDUINO or Cura with the USB cable.
-Concern for safety. Thermal runaway protection is enabled, if the temperature rises out of control, the printer will stop heating and halt automatically.

Support:
– Stepper Motor Driver based on TMC2208
– Voltage: Works on 12V and 24V
– Can Work For  CR-10S5.<You need to flash the firmware then you could use it>  Firmware Download

Creality V2.2 PCB:  
Different from Regular V2.2 Board, in the position of stepper motor driver chip, the resistance value is different (can be directly observed on the motherboard).
Conventional: R100 mute: R150